Buy Colgate ProClinical 250R Deep Clean Rechargeable Electric Toothbrush with 2 Brush Heads | Free Delivery to HK | Sailfish Online Store
Colgate ProClinical 250R Deep Clean Rechargeable Electric Toothbrush with 2 Brush Heads
Product Code: 2683384
Imported from Australia
Free Shipping (7-10 days)
Paypal, Bank Transfer or FPS
Designed with you in mind
Tongue & Cheek Cleaner
Helps remove odour causing bacteria. Power tip bristles clean hard-to-reach areas.
• Multidirectional sonic vibrations up to 30,000 strokes/min.
• Slim, lightweight handle easy to control & soft thin tipped bristles sweep along gum line.
• 2 minute timer with quadrant pacer.
• 5x plaque removal & healthier gums in 4 weeks
IMPORTANT INFORMATIONFor energy saving purpose, charge only when the battery level is too low. When not in use, keep the charger unplugged from the socket.
USAGE ADVICEFor optimal oral care, replace your brush head every 3 months and visit your dentist at least twice a year.
STORAGE INSTRUCTIONSThe following maintenance instructions are important to ensure that your brush continues to work as it was designed. Failure to follow these instructions may cause your device to stop functioning altogether. Densist and hygienists recommend replacing your toothbrush refill every 3 months. If you plan to stop using the toothbrush for an extended period, we recommend that you unplug the charging base, clean the toothbrush handle and heads, and store them in a cool dark place. If you start using your toothbrush again after a long period of nonuse, place it on the charger for at least 10 hours.
RECYCLABLE INFORMATIONRemove recyclable rechargeable battery in compliance with environmental regulations before disposing of the toothbrush. Do not open handle unless permanently disposing (will void warranty). To remove battery from handle: 1. Snap brush at stem. 2. Holding stem, slide brush internals out. 3. Pinch base of clear cover by switch area to release snaps, slide battery and circuit board out. 4. Using flat head screw driver, carefully pry battery away from housing and printed circuit board. Apply tape to terminals at ends of battery to avoid shorting.